Page 1 of 1

Bandicut installation problem (entry Point not found)

Posted: Wed Dec 30, 2020 6:11 am
by erkann
Hello,

I purchased bandicam+bandicut and i installed bandicam without observing any problem but When ı tried installed bandicut recieved below error in my pc. I send mail your support team didn't get a response yet and tried so much method for solving the problem closed all antivirus program on my pc and tried uninstall/install again still same. Do you have any suggestions with the problem?


The procedure entry point could not be located in the dynamic link library c:\Program Files\Bandicut\bd.cut.exe

Re: Bandicut installation problem (entry Point not found)

Posted: Wed Dec 30, 2020 11:42 am
by Bandicam Company
Hello,

Please uninstall Bandicut and download the latest version from https://www.bandicam.com/bandicut-video ... /download/ and try again.

Re: Bandicut installation problem (entry Point not found)

Posted: Wed Dec 30, 2020 4:14 pm
by erkann
Hello,

I tried with latest version problem is still continue..

Re: Bandicut installation problem (entry Point not found)

Posted: Fri Feb 12, 2021 9:41 pm
by geolson235
I just downloaded Bandicut and am having the same problem. I'm getting the error that the procedure entry point could not be located in the dynamic link library. Has anyone found a solution to this?

Re: Bandicut installation problem (entry Point not found)

Posted: Mon Feb 15, 2021 4:53 pm
by Bandicam Company
Please go to https://www.bandicam.com/bandicut-video ... /download/, and download/install the latest version of Bandicut, and then try it again

If you still have the problem, email us at bandicut@bandicam.com with a screenshot of the error message.